Structurally Insulated Sandwich Foam Panels Interior Partition Fireproof Cement Board

What makes wall board
5mmCalcium silicate board (face board) + EPS /Cement/Sand(core material) + 5mm Calcium silicate board (face panel)
      


Advantages

1. Heat Preservation: Major material is anti freezing, heat preserving and environmental friendly.
2. Heat Insulation: Adjust the indoor temperature at a constant range.
3. Fire Proof: 5mm calcium silicate board is fireproof, Eps Cement sandwich panel can be against high temperature for 4 hours.
4. Water Proof: Experiment has proved that water pool can be made by Eps cement sandwich panel without absorbing any water and no leakage at all after one year.
5. Sound Insulation: The inside of wall panel material (EPS polystyrene grain) has fine sound insulation and sound absorbing function.
6. Easy to Install: Using our installation material (PU foam and Cement Adhesive) is easy to build house.
7. Labor Cost Saving: As wall panel is easy and fast to construct, the labors can be cut down in the same work and time.
8. High Intension: Eps Cement sandwich wall panel can be nailed directly or hang heavies, it can be decorated by ceramic tile, wall paper and any decorations you like.
9. Earthquake Resistance: The quake proof performance of Eps cement sandwich wall panel is more than 7.5.
10. Space and cost Saving: 60 to 150mm,which is more thinner than the traditional block, so it can save a lot of construction space. Meanwhile, the constructure cost can also be saved instead of using the traditional blocks.

Application 

1. Partition,indoor wall, outdoor wall of non load bearing wall
2. The renovation of the old buildings
3. Other condition which have strong requirements of the moisture proof, waterproof, fireproof, sound insulation.

Installation steps

1. Setting the line and carrying the board into position.
2. Using a hand-hold electric saw cut to the sizes needed.
3. Sizing cement on tenon side of two boards, then spread specific mortar on one tenon side casually.
4. Carrying the board prepared to be installed to the installation place, correcting the wall board by
special tools, and making it close tightly. Then let the specific mortar squeeze out into full and then fixing it
with a wedge temporarily.
5. Planting bars in wall and pillar: drill a hole in the original pillar or wall, and fix the board by steel bars
6. Correcting and fixing: Using a guiding rule to check the vertical and leveling correction.
7.Planting bars in structure beam: drill a hole in structure beam and plant a reversed 7-shaped steel bar to fix with wall board.
8. Planting bars in floor: drill a hole in the floor and plant a 7-shaped steel bar to fix with wall board.
9. Planting bars between two boards, plant a steel bar in the angle of 45 degree to fix.
10. Installing electrical wires and switches: setting lines on the places needing to be set with concealed
wire and switch box.
11. Grouting and filling starch: filling and sticking the corrected wall board with polymer mortar.
12. Sticking anti-cracking tape.
After the mortar and wall are all shaped, sticking glass-cloth or anti-cracking tape, brushing coating.

How to install





 

Contact Us
Ian
Xiamen ZhongJingtai Building Materials Co.,Ltd
Web: zjteps.en.made-in-china.com
Tel:  86-592- 5216902   
Mobile: +8618577342631